What are Causes of Electric Oven Not working

Some common causes that your electric oven is not working are as follows

POWER SOURCE

• 240 volts of alternating current (AC) are required for today’s electric ranges, which are separated and routed by two 120 volt ac legs.
• The oven will not power up if only one leg of the voltage is shut down by a tripped breaker or a blown fuse.
• It’s possible that the power source isn’t getting enough juice for whatever reason. Using a multimeter, check the power source. Set the multimeter to volts AC and check the voltage between 210 and 240 volts. If not, proceed to the next step.
• Examine the circuit breaker and fuse box. If a breaker has been tripped or a fuse has blown, reset the breaker or replace the fuse before attempting to switch on the oven again. If the oven turns on, you’ve discovered the source of the problem.

BURNT WIRE CONNECTION

• The bake or broil power supply wires might burn out and cause obvious damage near the heating element.
• See if replacing the damaged wire or element solves the problem. If that doesn’t work, move on to the next troubleshooter.

THERMAL FUSE BLOWN

• Some electric types may break a thermal fuse if the oven gets too hot.
• A blown thermal fuse will turn off the oven’s power and prevent it from working.
• Check for continuity with a multimeter.
• Replace the fuse if the continuity test is negative. Proceed to the following step if the fuse is in good working order.

THERMOSTAT SENSOR FAILURE

• The oven may feature a thermostat or an oven control board that works with an oven sensor, depending on the model.
• The oven temperature is monitored by the thermostat or sensor. The oven control board turns off the power to the element when the oven reaches the required temperature. To keep the temperature consistent during the cooking process, this cycle is repeated.
• The oven may not turn on at all if the sensor or thermostat is malfunctioning.
• Use a multimeter to check the sensor’s resistance at room temperature. The display should show a resistance of 1100 ohms. If this is the case, the sensor should be replaced.

DEFECTIVE CONTROL BOARD

• The oven control board is most likely the source of the problem if the sensor indicates accurate resistance when tested.
• You can’t easily test the control board, but you can visually inspect it for evidence of burning or shorts.

There are a few parts in electric ovens that wear out and quit working. The top, bottom, and ring oven elements are the most prevalent portions. Most of the time, you can’t determine if an element is worn out by looking at it. However, the oven will not perform that job or will take a long time to heat up. It’s tough to brown meats and vegetables if the top element of the oven has ceased operating. The bottom of the pan will overheat at the same time. If your oven is not working or you don’t any idea also on Fridge Repair, Washing Machine Repairing then hire professional home appliances technician who resolve all of your problems in no-time.